- Hyper 212 evo install to a sabertooth 990fx how to#
- Hyper 212 evo install to a sabertooth 990fx verification#
I have used many of these Hyper 212 coolers over the years, and while other CPU coolers come and go, this remains the Ol’ Reliable when others fail. Best of all, this cooler is compatible with a wide range of motherboards and sockets allowing you to reuse it in rebuilds to save costs. Is the Hyper 212 EVO the most efficient CPU cooler ever made? Probably not, but if you are building or upgrading a system, the Hyper offers superb cooling and quiet operation at a low cost.
Either way, the resulting peace and quiet is welcome. However, the included Cooler Master fan is quiet enough, so there is little need to replace it. From my experience, I would say that the Noctua NF-F12 is more quiet at a higher RPM.
Hyper 212 evo install to a sabertooth 990fx verification#
The included CPU fan is one of the most silent CPU fans I have used. Form Responses sl,Linus Tech Tips Username,CPU Manufacturer,CPU Model,Current Motherboard,Motherboard socket,Current Cooler,Current Frequency,CPU Multiplier,CPU Bus Speed,Core Voltage,Max Temperature (In Degrees Celsius),Number Of Active Cores,Link To Verification Of Stability,BIOS Version,Defau. Certainly, it is a good idea to clean the dust from your system, and there will be dust on the Hyper over time, but it is nowhere near as bad as the stock cooler. The added heat fins are spaced further apart than the stock AMD cooler, so they do not become clogged with dust as often. The large heat sink with copper heat pipes and the quiet 120mm fan make a superb combination at a low cost. To learn more about the planned builds and get early.
Hyper 212 evo install to a sabertooth 990fx how to#
The Hyper 212 EVO is a purchase I am happy with. This is a tutorial 'How To' install the Cooler Master Hyper 121 Evo and how to install it for an i7-3770K on a Gigabyte Z77X-UP7 Motherboard. (This is an older, less efficient CPU.) Conclusion During a few unofficial measurements using BIOS reporting and psensor, the CPU stayed within 43-45C with the Hyper while the stock cooler raised the temperature to about 50C. Place the standoffs through the board from the top and secure them with a nut as shown below. ( Make sure that the covered feet of bracket are touching the bottom of the board. Place the back plate on board as shown Below. The CPU runs a few degrees Celsius cooler. Remove the OEM mounting bracket from the motherboard. Plus, the Hyper moves more air with its 120mm fan. Any sound the Hyper produces is lower and deeper compared to the high-pitched, tinny whine of the stock fan. However, while the Hyper’s fan is noticeable at 100% CPU, it is still much more quiet than the stock fan. During everyday computer usage, the CPU fan is almost inaudible, but it will ramp up when the CPU reaches 100% usage. The case with three fans is quieter than the one fan on the stock AMD cooler.
It is possible to arrange the heat sink so the fan blows upwards and out the top of the case.Īfter all of that work, is there any improvement? The two fans are in line with each other. The CPU fan blows air into the heat sink, and the outtake fan helps pull air out of the case.
The Hyper’s fan is almost inaudible at a low RPM, so this should not make much of a difference.